Fluke-biomedical QA-ES II Manuel d'utilisateur télécharger pdf (Page 23)

Electrosurgical Analyzer

Analyzer Menu and Function Keys

SETUP (F4)

Here you can set the power distribution level for start,

stop, and step in ohms.

F1 F2 F3 F4 F5

eju007.eps

Choose ‘Start load’ by using KNOB PARAM (F4). Use

the encoder to set the level. Save the level by pressing

ENTER (F5). Press CANCEL (F4) to undo an action. Go

to ‘End load’ and ‘Step Size’ and repeat the same

procedure.

Pwr. distr. Start load is the first load during the

measurements; it can be set from 10 ohms to 2100 ohms,

in increments of 25 ohms beginning at 25 ohms.

Pwr. distr. End load is the last load used in the

measurements; it can be set from 525 ohms to 5200

ohms, in increments of 25 ohms from 525 to 2500

ohms and 100 ohms from 2500 ohms to 5200 ohms.

Pwr. distr. Step Size is the load set with steps of 25, 50,

100, and 200 ohms.

QUIT MENU (F5)

Press this key to return to the main menu.

PRINT HEADER (F3)

Press this key to write a heading for a new test protocol.

REMOTE CONTR. (F4)

This selection enables you to control the Analyzer

through a PC, using the Ansur QA-ES Plug-in software

(optional accessory).

Printout

Press PRINT HEADER (F3) before printing out a page if

you want it to have a new heading. The Analyzer

automatically prints out the test results via the printer

output after every measurement. See Figure 3.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Pas de commentaire

Fluke-biomedical QA-ES II Manuel d'utilisateur Page 23