Fluke-biomedical QA-ES II Manuel d'utilisateur télécharger pdf (Page 20)

QA-ES II

Users Manual

Table 2. Controls and Connectors (cont.)

Item Name Description

L Terminals

RED and BLACK

Connection for the electrode outputs of the VAR. LOAD ESU. Attach the active electrode

to the red terminal and neutral electrode to the black terminal.

M Fuses T 200 mA at 230 VAC / T 400 mA at 115 VAC

N Printer Port 25 pin D-sub

O RS232 Serial Port 9-pin D-sub

P Voltage Selector 115 VAC/230 VAC

Q Mains Connector 3-pin connector to power cord

Main Switch On and Off

W Caution

To avoid damaging the Analyzer, ensure the

rear-panel voltage selector switch is set to

the correct mains voltage and the proper

mains fuses are installed for the selected

voltage. Refer to items 16 and 13 in Figure 2

to check the voltage and fuses respectively.

The main switch is located on the front panel (see item 5

in Figure 1). When turning the Analyzer off, wait at least

five seconds before turning it on again to allow the reset

circuit to unload.

Analyzer Menu and Function Keys

The Analyzer provides flexibility and control over the

operations with a display, programmable function keys,

and a setting regulator. The upper part of the LCD screen

displays messages, status, and results. The menu bar is

at the bottom of the display. The function keys range from

Fl to F5. Select a function by pressing the key located

directly under the menu bar item.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Pas de commentaire

Fluke-biomedical QA-ES II Manuel d'utilisateur Page 20